Sievers InnovOx TOC 仪器样本.pdf

Water Technologies&SolutionsSievers InnovOx ES Laboratory TOC Analyzers for organics monitoring*overviewSievers InnovOx ES Total Organic Carbon(TOC)Analyzers are designed to measure organic carbon in a broad range of water samples from industrial process water to wastewater influent and effluent to concentrated brine in chemical applications.All InnovOx ES Analyzers include robust sample handling capability and industry-leading supercritical water oxidation(SCWO)technology,designed to enhance performance and reliability in challenging applications.organics monitoring applicationsBiological wastewater plant optimization.Monitoring organics before and after treatment allows operators to optimize the F/M(food to microorganism)ratio,thereby enhancing organic removal,reducing sludge and chemical usage,and avoiding system upsets.Wastewater effluent monitoring and COD/BOD correlation.As an automated laboratory surrogate for time consuming and manual COD and BOD tests,the InnovOx ES TOC instrument help monitor the performance of a wastewater system.Optimizing the process provides confidence that regulatory testing results will be below permit limits.High-salt seawater and brine monitoring.Our patented SCWO oxidation technology was designed to measure organics reliably in high-salt or brine samples commonly found in the refining industry.Unlike combustion technologies that can easily be plugged or damaged by salt,the InnovOx oxidation reactor is self-cleaning and is not affected by salts coming out of solution.Industrial/commercial laboratory sampling.The InnovOx ES instrument with optional high-capacity Autosampler is ideal for reliably analyzing water samples from a broad range of sources including water reuse,cooling towers,boilers,research applications,or environmental testing.BOD or COD values are calculated based on the TOC measurement.InnovOx ES Laboratory TOC Analyzer Autosampler Protocol PC Interfacesupercritical water oxidation(SCWO)Supercritical Water Oxidation(SCWO)was originally developed to treat large volumes of aqueous waste,sludges,and contaminated soils.SCWO destroys organic wastes using an oxidant in water and temperatures and pressures above the critical point of water:375 C(770 F)and 22.1 MPa(3,200 psi).These conditions enable rapid and complete oxidation of organic carbon to CO2.Today,SCWO research and development is focused on treating a variety of toxic and hazardous organic wastes.Sievers Instruments is the first company to use this technique in a commercial laboratory TOC instrument.Supercritical Water Oxidation(SCWO)Organic+S 2 O 8 -2 +heat+pressure CO2+H2O+SO4-2 liquidsolid Supercritical fluid-not a gas or a liquidCritical pointTemperature oCPressure(psi)LiquidGasSolid 3200 15 375CNormalBoiling Pointproduct capabilities Wide dynamic range up to 50,000 ppm TOC Autosampler with stirring and rinse station options for high volume laboratory applications Patented supercritical water oxidation(SCWO)for superior TOC recovery and high reliability Reliable NDIR detection technology with no moving parts Straightforward operation Versatile measurement modes include TOC(TC-IC)or NPOC Handles tough TOC samples,like cellulose and brinecomplianceUS EPA Method 415.1 Organic carbon in drinking,surface,seawater,and waste waterUS EPA Method 415.3 Organic carbon in surface and drinking waterSW-846 Test Method 9060A Organic carbon in ground,surface,saline,and waste waterCEN Method DIN EN 1484 Organic carbon in drinking,ground,surface,sea,and waste waterISO 8245 Organic carbon in drinking,ground,surface,sea,and waste waterASTM D5173-Standard Guide for On-Line Monitoring of Total Organic Carbon in Water by Oxidation and Detection of Resulting Carbon DioxidePattern Approval Certificate for Measuring Instruments of the Peoples Republic of China,issued by General Administration of Quality Supervision,Inspection and Quarantine of the Peoples Republic of ChinaoptionsAutosampler For high-volume laboratory applications,the InnovOx ES Analyzer can be used with the Sievers Autosampler.It handles up to 120 35-mL sample tubes or up to 63 40-mL or 60-mL vials in one protocol.An optional stirring station creates a homogeneous mixture for analysis during the sampling process and an optional wash station reduces sample-to-sample carryover.Air FilterThe Air Filter is used to purify ambient air and pressurize it sufficiently for use as a sparge and carrier gas.It easily attaches to the back of the analyzer to avoid the use of external carrier gas cylinders.InnovOx measurements for brine,cellulose,and humic acid samplesReplicate 28%Brine 90 m Cellulose Humic Acid Solution Solution Solution (Process (100 ppm C)(10 ppm C)Sample)123456789MeanStand.Dev.RSD5.805.695.595.685.695.535.495.705.575.660.122.13%95.198.090.910493.298.093.310110397.34.504.63%10.210.110.410.410.210.210.49.919.8610.190.202.0%InnovOx ES Robust SCWO Oxidationindustries served Pharmaceutical Hydrocarbon Processing Pulp and Paper Food and Beverage Chemical Production Wastewater TreatmentFind a contact near you by visiting and clicking on“Contact Us”.*Trademark of SUEZ;may be registered in one or more countries.2017 Copyright SUEZ.All rights reserved.This information herein may be subject to change without notice and is provided for general guidance only.The dimensions and performance of systems,products and services may vary.Pictures are for example purposes and not to scale.All legal obligations are exclusively as set out in contractual documents.Nothing contained herein constitutes a representation,warranty or undertaking.300 00306 Rev N ISO 9001:2008QUALITY MANAGEMENT SYSTEM 6060 Spine Road Boulder,CO 80301-3687 USA T+1 800 255 6964 T+1 303 444 2009 F+1 303 527 system specifications operating specifications1 Analysis ModesRangePrecisionAccuracyLinearityLODTOC Calibration StabilityAnalysis TimeParticle Diameters in SampleSample TemperatureAmbient Temperature RangeSamplinganalyzer specificationsSample Capacity OutputsDisplayPower Installation/Overvoltage Category DimensionsDimensions(Autosampler)WeightSafety Certifications environmentMaximum Relative HumidityNormal OperatingMaximum AltitudePollution Degree NPOC,TOC(TC-IC),TC,IC 50ppb to 50,000ppmRSD 3%of reading at 5 ppm NPOC or TOCGreater of 3%or 0.25 ppm,1 to 100 ppm,NPOC or TOCR2 0.995,measured as NPOC50ppb NPOC mode2 Up to 6 months2.6 to 8.3 minutes800 m diameter10-60C (41-140F)10 to 40C (50-104F)Ambient pressure,0.08 to 2.82 mL sample volume per analysisUp to 120 with optional Autosampler3(or single standard vial port)Ethernet Port(1);USB Ports(3)Color LCD w/touch-screen 100 240 10%VAC,50 60 Hz,400 VAII H:52.05 cm(20.5 in.);W:32.26 cm(12.7 in.);D:58.42 cm(23.0 in)H:52.2 cm(20.5 in.);W:31.1 cm(12.25 in.);D:53.3 cm(21.0 in.)22.41 kg(49.4 lb);14.1 kg(31.1 lb)for optional Autosampler CE,ETL listed.Conforms to UL Std.61010-1.Certified to CSA C22.2 NO.61010-1Up to 95%,non-condensingIndoor use only.Keep instrument and reagents out of direct sunlight.3,000 m(9,800 ft)2 1.Stated analytical performance is achievable under controlled laboratory conditions that minimize operator and standards errors.2.NPOC mode,bottled N2 as carrier gas.This performance is achieved under controlled conditions where variables that influence low-level performance have been minimized or eliminated.This performance may not be achievable on instruments delivered before August 2016.3.Up to 63 sample tubes for 40mL and 60mL vials.Up to 120 sample tubes for 35mL vials.