模具零件中英文对照表.doc

模具零件名稱中英文對照一覽表零件名稱ENGLISH NAME零件名稱ENGLISH NAME上固定板TOP CLAMPING PLATE母模仁CAVITY母模板CAVITY PLATE公模仁CORE公模板CORE PLATE母模入子CAVITY INSERT模腳SUPPRORT BLOCK母模心子CAVITY INSERT PIN上頂出板 EJECTOR RET PLATE母模替換入子CAVITY CHANGEABLE INSERT下頂出板EJECTOR PLATE公模入子CORE INSERT 下固定板BOTTOM CLAMPING PLATE公模心子CORE INSERT PIN隔熱板THERMAL INSULATING PLATE公模替換入子CORE CHANGEABLE INSERT脫料板RUNNER STRIPPER PLATE滑塊入子SLIDE INSERT 母模墊板CAVITY SUPPORT PLATE滑塊心子SLIDE INSERT PIN公模墊板CORE SUPPORT PLATE斜銷入子Angle LIFTER INSERT脫料板STRIPPER PLATE斜銷心子Angle LIFTER PIN流道板RUNNER PLATE流道開關RUNNER SHUT OFF定位環LOCATING RINGT 形塊T GIB注口襯套SPRUE BUSHNGU形塊U GIB導柱LEADER PIN拉料銷SPRUE PULLER PIN導套LEADER BUSHING定位銷DOWEL PIN頂板導柱GUIDE PIN頂針EJECTOR PIN頂板導套GUIGE BUSHING扁銷RECTANGLE EJECTOR PIN大拉杆LARGE PULLER PIN套筒EJECTOR SLEEVE小拉杆SMALL PULLER PIN頂出塊EJECTOR BLOCK支撐柱SUPPORT PILLAR斜銷ANGLE LIFTER 定位塊INTERLOCKS斜銷座ANGLE LIFTER BASE定位柱LOCATION PILLAR引導塊GUIDE BLOCK開閉器(塑膠型)FRICTIONAL PULLERO 形環O RING彈簧SPRING冷卻棒THERMAL PIN運輸板PL LOCK止水塞brass pressure plug滑塊SLIDE隔水板STRAIGHT BUFFLE滑塊座SLIDE BASE水管接頭JIFFY TYTE PLUG滑軌SLIDE RAIL油封OIL SEAL后跟塊HELL BLOCK內六角螺釘SOCKET HEAD CAP SCREW耐磨板WEAR BLOCK等高螺釘SOCKET HEAD STRIPPER BOLT壓板RAIL吊模螺絲EYE BOLT限位塊STOP BLOCK吊環SAFETY HOIST RINGS定位夾SLIDE RETAINER彈簧墊圈SPRING WASHER定位珠SLIDE RETAINER加長型水管接頭EXTENSION JIFFY TYTE PLUG急回機構POSITIVE EARLY EJECTOR RETURN未注尺寸請參考3D MOLDEL:DONT MEASURE PLEASE REF 3D MODEL急回推杆LEVER入子孔單邊向外補正0.005MMINSERT HOLES TOLERANCE IS +0.005MM固定塊MOUNT AND COVER PLATE入子外形單邊向內補正0.005MMINSERT SHAPES TOLERANCEIS -0.005MM 彈簧片ARM全周AROUND熱處理HEAT TREATMENT0度起點0 START POINT表面氮化 SURFACE NITROGENIZED斜度轉折點ANGLE CHANGING POINT上限UPPER VALUER保持KEEP下限LOWER VALUER注口中心線SPRUE CENTER LINE插破SHUT OFF模具中心線MOLD CENTER LINE靠破SITTING咬花面TEXTURED SURFACE油溝槽深GREASE GROVER拔模角DRAFT ANGLE