高氯化聚乙烯铝粉防腐面漆的用途和使用.doc

高氯化聚乙烯铝粉防腐面漆的用途和使用
Intended Uses
用途
高氯化聚乙烯铝粉防腐面漆适用于各种金属结构、烟囱、管道、干式煤气柜，贮油罐外壁等设施的表面防腐，有优异的耐候性，耐化工大气腐蚀、反射光和热能力强，物理机械性能好、使用寿命长，与底漆中间漆的结合力强，干燥迅速，施工方便。
Suited for anticorrosive protection of surface including all metal structure, chimney, pipe. Dry gas tank etc. Excellent resistance to weathering and chemically atmospheric corrosion, good light and heat reflectivity, fair physical and mechanical properties, long service life strong adhesion to primer and intermediate coating, quick dry, Easy application                                                                                                
Product
Description
产品简介
Aluminum silver                   铝银色
Product
Information
产品数据
Volume Solids 固体份
35%
Dry Film Thickness干膜厚度
30microns               30微米
Theoretical Coverage 理论涂布率
10m2 /Kg               10平方米/公斤
Practical  Coverage 实际涂布率
Allow appropriate loss     允许适量损耗
Application Details
施工详述

Mix Radio 混合比
A:B=3:1(By weight)       甲：乙=3：1（重量比）
Method of Application      施工方法

   Airless Spray          无空气喷涂          Recommended        推荐采用

   Brush or Roller         涂刷或辊涂          Recommended        推荐采用

   Conventional Spray     传统喷涂          Not  Recommended     不推荐使用

Thinner                      稀释剂                  C001
Cleaner                      油漆设备清洗剂          C001
Pot Life                     使用期                 24hours                 24小时
Storage                      贮存期                  One year               一年
Drying time
干燥时间

Substrate
Temperature
底材温度,℃
Touch Dry
表干
（h）
Hard Dry
硬干
(H）
Over coating Interval
覆涂间隔

Mix最短
Max最长

10
25
35
   1
24
24 h
8 h
6 h
 Not limit 不限

Storage and
Handling
贮存与管理
 Storage        贮存           Store in cool and dry conditions    贮存于阴凉干燥处
Pack size      包装规格       A:25Kg in 20 liter container       甲：公斤装于20公升容器中
                            B: 5Kg in 5 liter container         乙：5公斤装于5公升容器中
Flash Point     闪点          38℃                        
Specific Gravity 比重         Approx1. 2Kg/L                  1.2公斤/公升

Specification and
Surface preparation
技术要求及表面处理
The surface to be applied must be clean and dry
在施工前应保持表面清洁、干燥。
Limitations
限制
Preceding coat: Highly chlorinated polyethylene anti-corrosive intermediate paint
前配套涂料：高氯化聚乙烯防腐中间漆

 Safety
  Precautions
   安全措施
The product must be used in painting area by professionals. When painting, please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product.
The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.
The paint contains volatile solvent and it is flammable, So must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks.
Enough ventilation is necessary at application sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye contact with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In case of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.
NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will NOT be responsible for any accident.
   本产品必须由专业人员在工业场所使用。使用时请务必参照本说明书以及相关健康安全手册。若客户在使用本产品前,未能详细了解本产品的相关健康安全知识,请与本公司人员联系。
该涂料为溶剂型涂料，为避免事故或危险发生，应采取最低限度的安全措施如下：
此涂料为易燃物,并含有挥发性易燃溶剂，故必须远离火星和明火。
严禁在作业场所吸烟，并应该采取有效措施，防止火星产生(如采用防爆电器设备，杜绝静电积累,避免金属撞击等)。
施工场所应尽量保持良好通风。为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10 %,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10 %的工作环境。 
采取有效措施，防止皮肤和眼睛与涂料直接接触(如使用工作服,手套,护目镜,面罩及涂防护油等)。若皮肤不慎与产品相接触,请用清水及肥皂或适当的工业清洁剂彻底清洗；若眼睛受到污染,请即刻用清水冲洗至少10分钟,并立即就医。
在施工时，建议佩戴面罩以免吸入漆雾和有害气体，尤其在通风不良的环境下，更要注意。最后请谨慎处理废旧漆桶以免污染环境。
  责任声明：对于未按本公司所要求采取有效得安全措施而引起的安全事故,本公司不负任何责任。
来源：江苏纽克莱涂料有限公司官网 http://www.nsk-