环氧抗静电地坪面漆的用途和数据说明.doc

环氧抗静电地坪面漆的用途和数据说明
Intended Uses
用途
用于具有抗静电要求的水泥，混凝土地板和壁墙表面涂装、如电子电器、印刷、纺织等厂车间、电器控制室，计算机房等。
Suited for the floor or wall requiring anti-explosive coating. Such as electric factory, control room, compnter room, printing factory, textile miss etc.
Product
Information产品简介
高固体份厚膜型环氧地坪涂料，双组份，漆膜耐磨，抗静电，哑光或高光，有限颜色。
High solid and high build epoxy floor paint, Two components with abrasion resistance, anti-static property semi-gloss or high gloss.
Application details
产品数据
Volume Solids 体积固体份
≥60%,
 Color       颜色
Grey, green, blue, red and yellow etc
灰、绿、蓝、红、黄等有限颜色
Dry Flm Thickness干膜厚度
50-200μm , according to the surface conditions
50-200μm ,视表面状况而定
Theoretical Coverage 理论涂布率
4.4-5.2 m2/kg at 100um of dry film thickness
4.4-5.2平方米/公斤，以100微米干膜厚计
以1mm干膜计时，为0.6-0.7 m2/kg （1.4-1.5 m2/kg ）
Practical  Coverage 实际涂布率
Allow appropriate loss    允许适量损耗
Storage and Handling
施工详述

Mix Radio 混合比
A : B=5:1(by weight)   甲:乙=5:1
Method of Application   施工方法

   Airless Spray     无空气喷涂        Recommended             推荐采用

Brush or Roller   刷涂或辊涂        Recommended             推荐采用

Air  Spray        有空气喷涂        Suitable, but diluting 10-20% is necessary
                                    适用，但需稀释10-20%
Thinner                      稀释剂                C003
Cleaner                      油漆设备清洗剂        C003
Pot Life                     使用期           35℃：2hours;    25℃:4hours;  15℃:6hours
                                              35℃：2小时;     25℃:4小时;   15℃:6小时 
Storage                      贮存期           one year          一年
Drying time
干燥时间

Substrate
Temperature
底材温度
Touch Dry
表干
（h）
Hard Dry
硬干
(h）
Fully  curing
完全固化
  （d）

35℃
25℃
15℃
≤2
≤4
≤6
≤12
≤24
≤36
≤3days 天
≤5ays 天
≤7days 天

Storageand
Handling
贮存与管理
Storage      贮存                Store in cool and dry conditions    贮存于阴凉干燥处     
Pack size    包装规格       A;20Kg in 20 liter container     甲:20公斤装于20公升容器中                      B:4 Kg in 4 liter container        乙:4公斤装于4公升容器中
Flash Point  闪点               ＞33℃ （Mixture, A, B）            ＞33℃ (混合物甲组份、乙组份)             
Specific Gravity  比重             1.15-1.35 Kg/L                        1.15-1.35公斤/公升

 Specification and
Surface preparation
技术要求及表面处理
All cracks, joint intersections, protrydent and hollow spots the floor have been prepared correctly and the floor has applied with primer sealer and paved with conductive copper film connecting ground,or other conducting coatings (such as conducting spackler or conducting interdiate coating) . Thus the surface must be for good effect.
This product cannot cure fully at low temperature. The substrate temperature should be maintained above 10℃ for good effect.

在涂覆本产品前，地板上所有裂纹、接缝、凸起、凹陷、均已正确处理，涂装了封闭底漆并已铺设了导电铜铂接地，也可在其他导电涂层上涂装（如导电腻子或导电中途漆），确保地面和清洁干燥。
本产品在低温条件下无法充分固化，为求最佳效果，底材温度应在10℃.
使用本产品，应现用现配，用多少配多少，并充分搅拌均匀，在使用期内用完，以免凝胶浪费。
涂装此涂料，初步干燥后，即可上人，完全固化后，才能投入使用。

 Safety
  Precautions
  安全措施
This product should be used in painting area by perfessional operators. When painting , please refer to Product  Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.参考
This product is a kind of solvent-based paint .Inorder to avoid  danger or accident, minimal safety precautions,as follow , should be down .
The paint contains volatile solvent and is flammable . So must keep away from sparks and open flames.No smoking at applacation site ,Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid producting sparks .Flash point of paint , mentioned  above on product Data sheet, is the lowest temperature at which mixture of the volatile materails of paint can ignite or explode with air. Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general, Therefore, 200m3of ventilation quantuty per 1Kg solvent (according to the solvent ) is necessary.
Product skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves,eye  protection, face  masks barrier cream and so on ). Kif paint gets in touch with skin , wass fully with large amount of fresh water and soap or appropriate commercial cleaner. In  case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation.
Handle empty containers with care and do not bring about environmental contamination.
NOTICE: If consumers have not taken effective safety precautions(Refer to the specfications), our company will NOTbe responsible for any accident.
   本产品由专业人缘在工业场所使用,使用时请参照本说明书及健康安全手册,如客户在使用本产品前,未能仔细了解有关产品的健康安全知识,请与本公司联系.
该涂料为溶剂型涂料,为避免事故或危险发生,应采取最低限度的安全措施如下:
此涂料为易燃物,并含有挥发性易燃溶剂,,故必须远离火星和明火,严禁在作业场所吸烟,并采取有效措施,防止火星产生(如采用防爆电器设备,杜绝静电积累,避免金属撞击等)本产品说明书中所列涂料及溶剂的闪点是引起燃烧的最低温度. 施工场所应尽量进行通风良好,为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10%,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10%的工作环境.
采取有效措施以防止皮肤和眼睛与涂料接触(如使用工作服,手套,护目镜,面罩及涂防护油等)如产品不慎接触到皮肤,应用温水及肥皂或适当的工业清洁剂彻底清洗,如眼睛受到污染,用清水冲洗至少10分钟,并立即就医.
建议佩戴通风面罩以避免吸入漆雾和有害溶剂气体,尤其在通风不良环境下施工时,细心处理旧漆桶以免污染环境.
  责任声明: 对于未按本公司要求采取有效安全措施儿引起的安全事故,本公司不负任何责任.
来源 http://www.nsk-