环氧树脂锌粉底漆.doc

环氧树脂锌粉底漆
Intended Uses
用途
环氧树脂锌粉底漆有机锌粉底漆，易涂装高性能防锈涂料，用于新建物及维护保养，适合於覆涂范围广泛的高性能防护面漆。
Organic zinc primer, easy application, high performance anti-corrosive coating, Suitable for maintenance and new-build construction, Able to overcoat with all short of protective finishes with high performance                                                                                                                 
Product
Description
产品简介
双组份,环氧底漆，干喷减少，快干快速涂装，良好的耐磨性，较少的运输和操作损伤。
Two packages， Epoxy zinc power primer, little dry spray, rapid drying and application, good abrasion resistance, less transportation and operation damage
Product
Information
产品数据
Volume Solids         固体份
≥65%
Dry Film Thickness    干膜厚度
75 microns equivalent to 115 microns of wet film
75 微米相当于115微米湿膜厚
Theoretical Coverage   理论涂布率
4.0m2 /Kg at above mentioned volume solids 75microns of dry film thickness
4.0平方米/公斤,以规定体积固体份和75微米干膜厚计
Practical  Coverage    实际涂布率
Allow appropriate loss    允许适量损耗
Application Details
施工详述

Mix Radio 混合比
A : B=10:1(by weight)   甲:乙=10:1
Method of Application     施工方法

   Airless Spray          无空气喷涂             Recommended        推荐采用

   Brush or Roller        涂刷或辊涂             Only applied to repair small area
                                                 仅适用于小面积修补
   Conventional Spray     传统喷涂               Suitable, using appropriate with stirrer.
                                                   采用配有搅拌器的适当设备
Thinner                      稀释剂                 Not necessary, if needed, use OUP C003
                                                  不需要，如需要用C003
Cleaner                      油漆设备清洗剂         C003
Pot Life                     使用期                  5℃:12h    25℃:10h    35℃:6h
Storage                      贮存期                  One year               一年
Drying time
干燥时间

   Substrate
Temperature
底材温度,℃
Touch Dry
表干,min
  Hard Dry
  硬干’h
Over coating Interval
覆涂间隔

Mix最短
Max最长

5
23
35
  45
  30
  20
24
16
      8
24  h
4  h
2  h
   14 d

Storage and
Handling
贮存与管理
Storage          贮存           Store in cool and dry conditions      贮存于阴凉干燥处   
Pack size        包装规格        A;40Kg in 20 liter container         甲:40公斤装于20公升容器中
                                B:4Kg in 4 liter container           乙:4公斤装于4公升容器中
Flash Point       闪点            ≥23℃ ( mixture)                  高于23℃(混合物)
Specific Gravity   比重            Approx 2.2Kg/L                  大约2.2公斤/公升

Specification and
Surface preparation
技术要求及表面处理
Remove dirt and oil and salt by solvent cleaning, Remove weld slag, smooth seams and sharp edges where the treatment is necessary. Blasted surface: Blast to Swedish Standard SIS055900 Sa2.5, if oxidation happens to the surface, blasting should be done again prior to painting this product
For the steel Standard SSPC –SP6-10, If the primer is damaged widely and seriously, the surface must be completely sweep blasted.
环氧树脂锌粉底漆用溶剂去除油污、油脂、和盐，在需要的地方去除焊渣，并磨平焊缝和尖锐边缘。
表面已发生氧化现象，则需再喷砂一次达到规定标准，涂装本品前如已经涂装底漆钢板表面，焊接缝及损伤部分需喷砂至瑞典（SPC –SP6-10）  Sa2.0-2.5- SIS055900，如果底漆产生严重散布的损伤，表面需要全部扫砂。

Limitations
限制

Maximum over coating interval is usually unlimited but it depends on the conditions of climate and environment.
The surface must be clean and free soluble zinc salts or excessive corrosive products before coating
The adhesive strength of zinc powder primer will be reduced if the film thickness after application is beyond the specified range. And even painting high-build finish may give rise to film peeling
环氧树脂锌粉底漆最大的覆涂间隔通常不限定，但需依气候和环境条件而定，覆涂前，表面需清洁干燥，无可溶解锌盐以及过多腐蚀产品，涂装不在上述规定的膜厚，锌粉底漆的粘结强度会下降，而且当复涂以高膜厚面漆时会引起漆膜剥落现象。

 Safety
  Precautions
  安全措施
The product must be used in painting area by professionals. When painting, please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product.
The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.
The paint contains volatile solvent and it is flammable, So must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks.
Enough ventilation is necessary at application sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye contact with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In case of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.
NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will NOT be responsible for any accident.
   环氧树脂锌粉底漆必须由专业人员在工业场所使用。使用时请务必参照本说明书以及相关健康安全手册。若客户在使用本产品前,未能详细了解本产品的相关健康安全知识,请与本公司人员联系。
该涂料为溶剂型涂料，为避免事故或危险发生，应采取最低限度的安全措施如下：
此涂料为易燃物,并含有挥发性易燃溶剂，故必须远离火星和明火。
严禁在作业场所吸烟，并应该采取有效措施，防止火星产生(如采用防爆电器设备，杜绝静电积累,避免金属撞击等)。
施工场所应尽量保持良好通风。为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10 %,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10 %的工作环境。 
采取有效措施，防止皮肤和眼睛与涂料直接接触(如使用工作服,手套,护目镜,面罩及涂防护油等)。若皮肤不慎与产品相接触,请用清水及肥皂或适当的工业清洁剂彻底清洗；若眼睛受到污染,请即刻用清水冲洗至少10分钟,并立即就医。在施工时，建议佩戴面罩以免吸入漆雾和有害气体，尤其在通风不良的环境下，更要注意。最后请谨慎处理废旧漆桶以免污染环境。  责任声明：对于未按本公司所要求采取有效得安全措施而引起的安全事故,本公司不负任何责任。
来源 江苏纽克莱涂料有限公司 http://www.nsk-