环氧导电腻子的用途和数据.doc

Intended Uses
用途
适用于防静电地坪面漆涂装前对地面进行铺平处理，以获得平整导电表面和有利涂装后道防静电面漆。
Used to repair and fill up the floor surface before painting with antistatic finish in order to provide smooth conductive surface for next coat.
Product
Information产品简介
具有优良的刮涂性，能厚刮，干燥后不收缩，不开裂，施工方便，涂层附着力强，强度高，电阻率低、表面细腻。
It can be applied by doctor blade. Thick film may be obtained. After drying, no contraction or crack takes place to the film. Easy to be applied. The film possesses good adhesion, high strength, and small electric resistance. Its apperance is smooth.
Application details
产品数据
Volume Solids 固体份
90%
Color 颜色
Black 黑色
Dry Flm Thickness干膜厚度
Depending on substrate smoothness. High thickness of film can be made with doctor blade method, if necessary.
与地面平整度有关该腻子可以根据平整度刮厚
Theoretical Coverage 理论涂布率
8.3-12.5 m2/kg（0.08-0.12 kg/ m2）），based on one coat with doctor blade application
刮涂一道为8.3-12.5 m2/kg（0.08-0.12 kg/ m2　）
Practical Coverage 实际涂布率
Allow appropriate loss 允许适量损耗
Storage and Handling
施工详述

Mix Radio 混合比
A : B=5:1(by weight) 甲:乙=5:1
Method of Application 施工方法
Doctor Blade 刮涂 Recommended 推荐采用
Pour the mixture on the floor and apply quickly with
Doctor blade 将混合好的浆料倒在地板上，尽快刮平
Airless Spray 无空气喷涂 Unsuitable 不适用
Brush or Roller 涂刷或辊涂 Unsuitable 不适用
Conwentional Spray 传统喷涂 Unsuitable 不适用
Thinner 稀释剂 Ingenral, uncessary. If necessary, use C003
一般不需要，如需要使用 C003
Cleaner 油漆设备清洗剂 C003
Pot Life 使用期 For Summer 夏用型：35℃：20-35 min; 25℃:30-45min
For Winter 冬用型：15℃：30-45min; 5℃:45-60 min
Storage 贮存期 One year 一年
Drying time
干燥时间

Substrate
Temperature
底材温度
Touch Dry
表干
（h）
Hard Dry
硬干
(h）
Fully Curing
完全固化
（d）
35℃
25℃
15℃
5℃
≤4
≤8
≤8
≤12
≤8
≤12
≤12
≤24
≤1
≤3
≤3
≤5

环氧导电腻子的用途和数据

Storageand
Handling
贮存与管理
Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处
Pack size 包装规格 A;20Kg in 20 liter container 甲:20公斤装于20公升容器中 B:4Kg in 4liter container 乙:4公斤装于4公升容器中
Flash Point 闪点 ＞65℃ （Mixture, A, B） ＞65℃ (混合物、甲组份、乙组份)
Specific Gravity 比重 About 1.40Kg/L 约 1.40公斤/公升
来源

Specification and
Surface preparation
技术要求及表面处理
Prior to application. All cracks, joint intersections, protrydent and hollow spots the floor have been prepared correctly and the floor has applied with primer sealer or other coatings (such as spackle or resin mortar). The surface must have been sealed up and it is smooth, clean and dry. Other information about the floor preparation methods please read the seal primer manual or consult with our company.
This product can be applied directly over conductive substrate (such as metal and terrazzo anti-static.).
Recommend to use the paint or summer if the substrate temperature is above 20℃ and use the paint for winter. If the substrate temperatureis in the range of 0-20℃. But the coat cures very slowly below 5℃.
Must mix conponent A and B according to the pratical necessary quantity. Recommended making this paint just before painting with it. Should stir to even before application. It should be used up in its pot life in case it would cure and chould not be used.
When the film is hard dry, paint with subsequent coat.
在涂覆本产品前，地板上所有裂纹、接缝、凸起、凹陷、均已正确处理，并涂装了封闭底漆或其他涂层（如腻子层或树脂砂浆层），确保地面完全封闭，基本平整和清洁干燥，相关地面处理方面请参看封闭底漆说明书或向本公司咨询。
该产品也可直接在导电基材上涂装，如金属、防静电水磨石等。
涂装环境温度在20℃及以上时，建议采用夏用型；在0-20℃时，采用冬用型，但在5℃以下时，涂料固化缓慢。
使用本产品，应现用现配，用多少配多少，并充分搅拌均匀，在使用期内用完，以免凝胶浪费。
涂料初步干燥后，即可涂装后道涂料。

Safety
Precautions
安全措施
This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.
This paint product contain a spot of solvent, minimal safety precautions, as follow, should be done in order to avoid danger or accident.
In general this painthas no danger of explosion. However enough ventilation is necessary at application site.
Because the paint is flammable, Protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves,eye protection, face masks barrier cream and so on ). Kif paint gets in touch with skin , wass fully with large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation.
Handle empty containers with care and do not bring about environmental contamination.
NOTICE: If consumers have not taken effective safety precautions(Refer to the specfications), our company will NOTbe responsible for any accident.
本产品由专业人缘在工业场所使用,使用时请参照本说明书及健康安全手册,如客户在使用本产品前,未能仔细了解有关产品的健康安全知识,请与本公司联系.
该涂料含少量溶剂,为避免事故或危险发生,应采取最低限度的安全措施如下:
此涂料为易燃物，应远离明火。
一般情况下无爆炸危险，但仍应适当通风以改善涂装环境。
应漆液并非无害，所以仍应采取有效措施以防止皮肤和眼睛与涂料接触(如使用工作服,手套,护目镜,面罩及涂防护油等)如产品不慎接触到皮肤,应用温水及肥皂或适当的工业清洁剂彻底清洗,如眼睛受到污染,用清水冲洗至少10分钟,并立即就医.
建议佩戴通风面罩以避免吸入漆雾和有害溶剂气体,尤其在通风不良环境下施工时。
细心处理旧漆桶以免污染环境.
责任声明: 对于未按本公司要求采取有效安全措施儿引起的安全事故,本公司不负任何责任.