资源描述
,*,单击此处编辑母版标题样式,单击此处编辑母版文本样式,第二级,第三级,第四级,第五级,单击此处编辑母版标题样式,单击此处编辑母版文本样式,第二级,第三级,第四级,第五级,*,1,Unit 6 How to Write the Introduction,2,Teaching Procedures,Lead-in,1,Sample Analysis,2,Building a Model,3,Grammar and Writing Skills,4,3,1.What information should be contained in the Introduction?,Lead-in,Background,Literature Review,Unresolved Question,The Present Paper,4,2.What is the purpose of writing the Introduction?,3.How does the Introduction differ from the Abstract?,4.How do writers normally start the Introduction?,5.What type of information should be included in the Introduction,and in what order?,6.How do writers normally end the Introduction?,5,Typical complaints of referees,The Introduction occupies too high a proportion of the entire paper and contains too many general statements that are widely known.The rational and objectives are not defined and the whole section is completely,disorganized-it is not clear what problem the author is addressing or trying to solve and why they chose their particular methodology.,Much of the initial part is essentially a cut and paste from the Abstract.,6,The author has not related the background information to the objective of the paper.,Please remember that the paper may be read by inexperienced Ph.D.students or others starting their work in your specific field.Hence,please add an explanation or at least a reference when mentioning notions related to and terminology for,7,Introduction,1.,Polylactide(PLA)has received much attention in recent years due to its biodegradable properties,which offer important economic benefits.,2.,PLA is a polymer obtained from corn and is produced by the polymerization of lactide.,3.,It has many possible uses in the biomedical field,1,and has also been investigated as potential engineering material.,2,3,4.,However,it has been found to be too weak under impact to be used commercially.,4,5.,One way to toughen polymers is to incorporate a layer of rubber particles,5,and there has been extensive research regarding the rubber modification of PLA.,6.,For example,Penney et al.showed that PLA composites could be prepared using blending techniques,6,and more recently,Hillier established the toughness of such composites.,7,7.,However,although the effect of the rubber particles on the mechanical properties of copolymer systems was demonstrated over two years ago,8,little attention has been paid to the selection of an appropriate rubber component.,8.,The present paper presents a set of criteria for selecting such a component.,9.,On the basis of these criteria it then describes the preparation of a set of polymer blends using PLA and a hydrocarbon rubber(PI).,10.,This combination of two mechanistically distinct polymerizations formed a novel polymer in which the incorporation of PI significantly increased flexibility.,Sample Analysis,8,In sentence 1 the writer establishes the importance of this research topic.,In sentence 2 the writer provides general background information.,In sentence 3 the writer does the same as in Sentence 1 and2,but in a more specific/detailed way.,In sentence 4 the writer describes the general problem area or the current research focus of the field.,9,In sentence 5 the writer provides a transition between the general problem area and the literature review.,In sentence 6 the writer provides a brief overview of key research projects in this area.,In sentence 7 the writer describes a gap in the research.,In sentence 8 the writer describes the paper itself.,In sentence 9 the writer gives details about the methodology reported in the paper.,In sentence 10 the writer announces the findings.,10,Background,Literature Review,Unresolved Question,The Present Paper,(sentences 1-4),(sentences 5-6),(sentence 7),(sentences 8-10),11,Background,1.,Polylactide(PLA)has received in recent years due to its biodegradable properties,which offer,.,2.,PLA a polymer obtained from corn and produced by the polymerization of lactide.,3.,It has,in the biomedical field,1,and has also been investigated as potential engineering material.,2,3,4.,it has been found to be too,under impact to be used commercially.,4,important economic benefits,much attention,However,weak,is,is,many possible uses,12,Literature Review,5.,One way to,polymers is to incorporate a layer of rubber particles,5,and there has been,regarding the rubber modification of PLA.,6.,Penney et al.,that PLA composites could be prepared using blending techniques,6,and more recently,Hillier the toughness of such composites.,7,toughen,extensive,research,For example,showed,established,13,Unresolved Question,7.,although the effect of the rubber particles on the mechanical properties of copolymer systems was demonstrated over two years ago,8,to the selection of an appropriate rubber component.,However,little attention has been paid,14,The Present Paper,8.,presents a set of criteria for selecting such a component.,9.,On the basis of these criteria it then,the preparation of a set of polymer blends,PLA and a hydro-carbon rubber(PI).,10.,This combination of two mechanistically distinct polymerizations polymer in which the incorporation of PI,.,The present paper,describes,using,formed a novel,significantly increased,flexibility,15,Building a Model,Background,Establish the importance of the field.,Provide background facts/information(possibly from research).,Present the problem area/current research focus.,16,Literature Review,Review previous or current research.,17,Unresolved,Question,Locate a gap in the research.,Describe the problem to be addressed.,Present a hypothesis to be tested.,18,The Present,Paper,Introduce the purpose of the research.,Introduce the approaches or the main procedures.,Present the major findings.,State the significance of the research.,Outline the structure of the paper.,19,20,The“Funnel-Shaped”structure,You may begin with information on the importance of the,overall topic,being addressed.,Next summarize knowledge about,an aspect,of the topic.,Then identify,an unresolved question,about that aspect.,Finally say,how the current research addressed the question,.,21,Most research papers in basic science are,investigative,.That is,they are based on specific research questions you try to answer or on a particular hypothesis you try to test.Introductions for these papers should contain the four elements.,22,Special case:Introductions for Descriptive Papers,Some research papers are not written to answer specific questions or prove a hypothesis but rather to,describe,a new finding.Introductions for these papers follow a slightly different“funnel”structure because elements that readers expect to find in the Introduction of a,descriptive,paper differ from those of an investigative paper.,23,1.Background,background information and,previous research in the area,2.Discovery statement,new discovery made by your,research,3.Experimental approach,approach taken toward,(optional),analyzing this discovery,4.Description,description of the new element,5.Implication,importance of the findings,24,Grammar and Writing Skills,Tense,Passive/active voice,25,The Present Simple,is generally used to describe the general background context,i.e.what is known already.,S1.The physical process of fragmentation is relevant to several areas of science and technology.,26,The Present Perfect,is used to show how the problem has been approached from the past until the present study.,S2.Because different physical phenomena are at work during the fragmentation of a solid body,it has mainly been studied from a statistical viewpoint.,27,The Past Simple,is used to review individual research.,At the end of the Introduction,the Present Simple,is used again when the authors state what they will do in the rest of their paper.,A general convention(but not rule)is that,the Past Simple,is used to present findings.,28,Passive/Active voice,In the Introduction you usually say what you will be doing or presenting in the research article.You can use,we,to refer to your research group or team,but do not use it to refer to people or humanity in general.If you are referring to people in general,its better to use a construction with,It,(,It is known/thought that,)rather than,We know/think that,You can use words like,here,and,in this study,to let your reader know when you are referring to your own work.,29,Review of the Literature,1.What key skills are needed when writing a Review of the Literature?,The key skill is to provide readers with just the right amount of literature regarding the sequence of events leading up to the current situation not too much to make it tedious,nor too little so that the context of your research is not meaningful to them.,30,The amount of detail you need to give varies immensely from discipline to discipline.In some disciplines you may be required to have a very strong theoretical framework for your study,thus requiring two or more pages.In other disciplines just one paragraph may be enough.,31,2.What are the two main reference systems?List their advantages and disadvantages.,32,Name and Year System,A system of referencing in which a reference is cited in the text by the last name of the author and the year of publication,e.g.,Smith(1990).,33,Name-year system,Advantages:,1)Because the references are unnumbered,references can be added or deleted easily.,2)Readers familiar with a field can recognize the authors of a citation without having to refer to the reference list.,3)It helps readers identify whether the sources of the citation are outdated or not.,34,Disadvantages,1)It may increase printing expenses.,2)The references take up space in the main body of the text and distract readers,especially when many works are cited together.,35,.Citation-order/Citation-sequence,System,A system of referencing in which references are cited in numerical order as they appear in the text.Thus,the References section is in citation order,not in alphabetical order.,36,Advantages:,1)It is convenient for readers to refer to the references.,2)Citation by numbers interrupt only slightly the reading of text.,3)This system also reduces printing expenses.,37,Disadvantages:,1)Readers usually have to turn to the reference list to find out whose work is being cited.,2)When authors must add or delete references at a late stage in revising a paper,they may be burdened with renumbering references.,38,3)It is not ideal for the reader,because the non-alphabetical presentation of the reference list may result in separation of various references to works by the same author.,39,3.What is the clearest way to refer to other authors?Should I focus on the authors or their ideas?,There are various styles for making reference to other authors.The four styles below contain the same information,but the focus is different.,40,Style 1,Blinco 1992 found,that American elementary school children showed,Style 2,In 5 Blinco found,that American elementary school children showed,Style 3 A study of the level of persistence in school children,was presented by Blinco 1992.,Style 4 A greater level of persistence has been noticed in America,5.,41,Summary,Introduction guidelines,:,1.Interest your audience and provide context.,2.Follow the funnel structure.,3.Keep the Introduction short.,4.Provide pertinent background information.,5.State the central point(question/purpose or,discovery statement)precisely.,6.State the experimental approach briefly.,7.Signal all the elements of the introduction.,42,The first sentence of the first paragraph,introduces,the main topic(cultural difference),and the rest of the paragraph,briefly reviews,a major study on this topic.The implications of this study(culture as the remaining variable)are summarized at the end of the paragraph.,The first sentence of the second paragraph,then,moves on to,the next major study.,The first sentence of the third paragraph,summarizes,the findings of the first two paragraphs,in order to,introduce some more recent findings.,43,Assignment,Read the Introductions of your target papers and identify the four components.,Write an Introduction based on your own experiment and research.,44,Summary Writing,1.What is a summary?,A summary is a,brief,restatement,in your own words,which gives the,gist,of a piece of writing.,2.What kind of information should be included in a summary?,A summary should include only main ideas and important supporting information.It should not include details or any personal opinions.,45,3.How is a summary the same as the original work?,A summary should have the same basic meaning as the original work.In other words,the summary should not have new or different information that is not in the original work.,46,4.How is a summary different from the original work?,A summary should not include many of the exact words as the original work.The writer should use,his or her own words,in the summary to express the same general ideas found in the original work.,Do not blindly copy out whole phrases and sentences from the text.,On the other hand,it is impossible to avoid using some of the words used in the original text.,47,Using your own words when writing a summary not only helps you understand the meaning but also constitutes the first step in avoiding plagiarism.,48,How to write a summary,1)Understanding the meaning.,2)Understanding the organization.,Work through the text to identify its sectionssingle paragraphs or groups of paragraphs focused on a single topic.,49,3)Distill each section.,Focus on the main point of the section,omitting examples,facts,and other supporting evidence.,4)State the main idea.,Write a sentence or two capturing the authors central ideas.,5)Support the main idea.,50,Qualities of a Summary,Quality One,The summary should,not,contain any of the,summary writers own,ideas,opinions,conclusions or judgments.,51,Quality Two,The summary writer should follow the,logical order,of the original passage.,52,Quality Three,The summary should contain,every,main idea,in the original passage.,53,Quality Four,The summary should be a,faithful,account of the original passage.,54,There is not a perfect way to write a particular summary.One person may choose to write a summary one way,and another person may write it in a slightly different way.As long as the summary highlights all the main ideas,is not too long(doesnt contain too many details),and does not have the same wording as the original work,it can be a good summary.,55,Identifying Summary Problems,It uses too many of the same words as the original.,It is too short.,It is too long and contains too many details.,It doesnt contain all the main ideas.,It contains an opinion.,
展开阅读全文